Atlanta Brick Repointing
Eroded joints cut back to depth and repacked with matched mortar — restoring the wall’s weather seal before the brick starts paying for it.
Joints Cut To Depth, Not Skimmed Over
Brick Repointing in Atlanta
Brick repointing in Atlanta is the maintenance that decides whether a wall lasts another fifty years or starts losing brick. Mortar is designed to erode first — it is the sacrificial element, deliberately weaker than the brick around it. That works perfectly right up until nobody replaces it.
Once joints recede far enough, water stops running off the face and starts running into the wall. From there it saturates the brick, freezes on cold nights, blows faces off and eventually reaches the structure behind. Repointing at the right moment is cheap; rebuilding afterwards is not.
We repoint homes, chimneys, garden walls and retaining walls across metro Atlanta, cutting joints back to proper depth and repacking with mortar matched to the original in strength, colour and profile.
Get A Free Estimate
Our Brick Repointing Services in Atlanta
Whole elevations, single problem areas and the awkward high-level work most contractors would rather skip.
-
Full Elevation Repointing
Complete walls cut out and repacked to a consistent profile. Doing a whole face at once avoids the patchwork appearance you get from repointing in stages as each area finally fails.
-
Spot Repointing
Localised repair where only one area has gone, typically beneath a leaking gutter or beside a downpipe. We match the surrounding mortar closely and identify what concentrated the water there.
-
Chimney Repointing
The most exposed masonry on any house, taking weather on four faces with no roof over it. Chimney joints fail first, and repointing them is usually the cheapest leak repair a homeowner will ever make.
-
Garden and Retaining Walls
Freestanding and retaining walls repointed on both faces where accessible. Retaining walls need their weep holes checked and cleared at the same time, since blocked drainage is what destroyed the joints.
-
Historic Lime Repointing
Period properties repointed with lime-based mortar matched to the original. Modern cement mortar on soft historic brick causes spalling, so on older Atlanta homes the mix is the whole decision.
-
Colour and Profile Matching
Test panels mixed and cured on site so you approve the real dried colour, not a wet guess. We match the joint profile too, since concave, weathered and flush joints all read very differently.
Why Choose Our Brick Repointing Company in Atlanta
-
Raked to Twice the Joint Width
New mortar needs real depth to key into. We cut back roughly twice the joint width, because skimming a thin layer over failed mortar produces a repair that falls out within a couple of seasons.
-
The Mix Suits the Brick
We match mortar strength to the brick, not to habit. Hard cement mortar on soft brick transfers stress into the brick faces and destroys them, which is the most common damage we are called to undo.
-
Cured Sample Panels
Wet mortar looks nothing like dry mortar. We point a discreet test area and let it cure so you can judge the actual colour against your wall before committing the whole elevation.
-
Careful Cutting Out
Aggressive grinding widens joints and chips brick edges permanently. Our crews work carefully, and by hand wherever the brick is soft or the bond pattern is historically significant.
-
We Explain Why It Failed
Mortar rarely fails evenly. Where one area has gone, something is directing water at it, and we point out the gutter, sill or flashing responsible so you are not repointing the same patch again.
-
Protected, Tidy Sites
Repointing is dusty. We sheet windows, paving and planting, clean down daily and leave the property properly, which matters when the work runs across an occupied home for a week or more.
Cost of Brick Repointing in Atlanta
Brick repointing costs in the Atlanta area generally fall between $8 and $25 per square foot, with most homeowners spending between $2,000 and $8,000 depending on the size and condition of the brickwork. A typical 100-square-foot project averages around $1,450, or roughly $14 to $15 per square foot, though costs can range as low as $400 or as high as $2,500 for that same area depending on mortar condition and accessibility.
Atlanta’s humidity and seasonal rainfall accelerate mortar breakdown, making repointing a common maintenance need for homes and commercial buildings with aging brick facades. Mortar typically fails within 20 to 30 years, and Georgia’s heavy rainfall and humidity tend to speed up that timeline compared to drier regions.
Atlanta Brick Repointing Cost Breakdown
| Project Type | Typical Cost Range | Notes |
|---|---|---|
| Standard wall repointing (up to 8 ft) | $3–$20 per sq ft | Lower end for accessible, good-condition brick |
| Wall repointing above 8 ft | $5–$25 per sq ft | Requires scaffolding |
| Full brick facade project | $6,000–$14,000 | Typical standard-size home facade |
| Small area (300 sq ft, good condition) | $1,800–$4,500 | Light tuckpointing only |
| 100 sq ft average project | $400–$2,500 (avg. $1,450) | Varies by mortar damage |
| Chimney repointing (residential) | $700–$2,500 (avg. $1,450) | Up to $5,500 for larger or hard-to-access chimneys |
| Chimney rebuild (if repointing insufficient) | $5,000–$15,000+ | Needed when mortar failure has progressed too far |
| Mortar analysis (pre-project) | $200–$500 | Ensures new mortar matches existing composition |
Please note this is only an estimate. You can get a more accurate quote when you call our team or provide specific project details in our contact form.
Brick Repointing FAQs
How much does brick repointing cost in Atlanta?
Repointing is priced by the square foot of wall, adjusted for joint width, how hard the old mortar is to cut out and what access the elevation needs. A single chimney is a modest job; a whole two-storey elevation requiring scaffolding is a much larger one. We measure and quote per elevation.
How do I know if my brick needs repointing?
Run a key along a joint. If mortar crumbles away as powder, or you can rake it out more than a quarter inch, the joints have stopped keeping water out. Other signs are visible gaps, mortar sitting in the flower bed below, and damp patches appearing on inside walls.
How long does repointing last?
Correctly specified repointing lasts thirty years and often considerably longer. The variables are mortar mix, joint preparation and weather during curing. Work that fails within a few years was usually pointed over dirty joints, cut too shallow, or done in a mortar far too strong for the brick.
What is the difference between repointing and tuckpointing?
Repointing is the structural repair: cutting out failed mortar and replacing it so the wall sheds water again. Tuckpointing is a decorative technique using two mortar colours to create the illusion of very fine joints. People often say tuckpointing when they mean repointing, and repointing is usually what the wall needs.
What is the best time of year to repoint brick in Atlanta?
Spring and autumn. Fresh mortar needs to cure slowly and damp, so mild temperatures suit it best. We avoid pointing in freezing conditions, which ruins the mix, and in peak July sun, which dries joints before they gain strength. We shade and mist the work when summer pointing is unavoidable.